Waste gas incinerator waste gas incinerator factory how to deal with the concentration of organic waste gas?
Release time:
2023-04-23
The waste gas incinerator of the waste gas incinerator manufacturer is the mainstream waste gas treatment equipment on the market at present, and it is a kind of organic waste gas treatment equipment. Compared with the traditional catalytic combustion and direct combustion thermal oxidation furnace (TO), it has the characteristics of high thermal efficiency (≥ 95%), low operating cost, and can handle large air volume and low concentration exhaust gas.

1. Production process of waste gas incinerator
The advantage of the waste gas incinerator of the waste gas incinerator manufacturer is that when the concentration is slightly higher, the secondary waste heat can also be recovered, which greatly reduces the production and operating costs. Most existing RTO systems use catalysts for virtual heating, but the catalysts age, require frequent replacement, and require disposal of spent catalysts. This process is troublesome. Now, heat storage materials are used instead of catalysts. The heat storage material body has been greatly reduced to a very economical price. For procurement and replacement, it will be much cheaper than using catalysts.
2. Three-chamber RTO furnace body
The main structure of the RTO exhaust gas treatment equipment consists of a combustion chamber, a regenerator, and an on-off valve. According to the actual needs of customers, choose different heat recovery methods and on-off valve methods. The treatment principle is to heat the organic waste gas to 760°C (depending on the composition) to oxidize and decompose the VOC in the waste gas into carbon dioxide and water. The high-temperature gas generated by oxidation flows through a special ceramic heat storage body, which heats up the ceramic body and "stores heat". This "heat storage" serves to preheat the organic waste gas which subsequently enters. This saves fuel consumption for exhaust gas heating. The ceramic regenerator should be divided into two or more, and each regenerator should go through heat storage, heat dissipation, cleaning and other procedures in turn, and work continuously.
3. Industrial waste gas treatment equipment, waste gas incinerator
RTO waste gas treatment equipment is suitable for treating waste gas with a concentration of 100~4500mg/m (recommend ≥ 100mg/m). Under appropriate waste gas concentration conditions, self-heating operation can be realized without adding auxiliary fuel, with high purification efficiency (three rooms> 99%), less maintenance workload and safe and reliable operation. The organic deposits can be cleaned regularly, the heat storage body can be replaced, the pressure loss of the entire device is small, and the service life of the device is long.
4, waste gas incinerator manufacturers of waste gas incinerator current problems
(1) Materials
After long time operation, the heat storage body often breaks, and the poor thermal shock resistance is a big problem. The heat storage material should be placed in an environment with large temperature changes and corrosive gases, and it should be affected by the stress caused by the huge temperature difference for a long time. The thermal shock resistance of the heat storage material must be good; considering the manufacturing cost of the equipment, a high-density material is required to reduce the volume of the regenerator. But in general, the higher the density, the worse the thermal shock resistance.
(2) Bias flow
In the heat exchange process in the heat storage chamber, if the exhaust gas has a bias flow in the heat storage chamber, the heat storage temperature is likely to be uneven after multiple cycles, resulting in thermal stress, and deformation when the limit of the heat storage body is exceeded.
(3) Secondary combustion
In general, the gas nozzle and the fuel nozzle of the RTO combustion system are separate, which is conducive to the formation of a low-oxygen environment, thereby forming a uniform temperature field and improving the heating effect. In the design, the parameters of the two jets of gas and fuel need to be accurately selected. Inadequate selection of parameters may result in insufficient combustion. After the mixed gas enters the regenerator, it will re-contact with the fuel to produce a combustion, and the local high temperature released will easily melt the regenerator.
Key words:
Recommend News