Waste gas incinerator manufacturers: precautions for waste gas incinerator?


Release time:

2022-11-24

Exhaust gas incinerator is widely used, because of its various advantages, it is also a very popular product in the market. But it also has a lot of need to know when using knowledge, after all, there are many users do not understand these. NextWaste gas incinerator manufacturersJust to introduce the matters needing attention for everyone? If you are interested, you can read it.

废气焚烧炉厂家:废气焚烧炉的注意事项?

Waste gas incinerator manufacturers tailor-made products for users in various industries. Hot products are widely used in petroleum, chemical, metallurgy, coating, steel and other industrial fields.Waste gas incinerator manufacturersWhat we need to know is the explosion in the pipeline, most of which is the sudden volatilization of a large number of organic liquids in the pipeline, and then generate static electricity. It is difficult to manufacture anti-static facilities for pipelines transporting corrosive gases. At this time, the wind speed can only be reduced, and the wind speed designed below 8 m/s is more appropriate. Or the open flame in the furnace is difficult to enter the pipeline from the workshop, because there is a heat storage ceramic, about 2m high, and the heat storage body itself is a good flame arrester. Flame arrester can be installed at the front end of the pipeline to further ensure the safety of the production workshop. In this waste gas incinerator manufacturers also recommend that you purge before ignition. The purpose of purging is to clear the residual organic matter in the pipeline and furnace to avoid explosion during ignition. And there is a concentration detector at the entrance, and the response time is about 5s, so the installation position of the concentration detector is more important, and a buffer tank should be used. Concentration and dilution; alarm when the exhaust gas concentration is high, cut off the connection with the production line, and the exhaust gas is directly bypassed to the chimney.

Of course, in actual production, no amount of measures can prevent the explosion, so the explosion venting device, such as the explosion venting door on the furnace roof, can be closed by its own weight and will not affect the normal R after the explosion. Running; the buffer tank has a blast opening. With these venting measures, even if an explosion occurs, the damage from the explosion will be reduced to many low levels. In addition, when in use, it is still very afraid of sudden power failure. The high temperature in the furnace cannot be quickly dispersed, which will cause many anti-corrosion materials or other equipment to be damaged by high temperature. The manufacturer of waste gas incinerator indicated that it designed emergency compressed air storage tank, UPS and explosion-proof door with manual and automatic control. In the event of a sudden power failure, the UPS and emergency compressed air storage tanks will hit all the air doors to safe positions, such as opening the fresh air door and opening the purge door. The explosion-proof door is opened, etc.; then the emergency compressed air enters the burner pipeline to avoid the leakage of high-temperature flue gas from the burner, causing the danger of igniting the pipeline and damaging the burner. But the compressed air tank can only support about 15-20min.Waste gas incinerator manufacturersIndicates that Party A needs to provide backup power for compressed air or combustion fan.

The content of the above article is about the matters needing attention of waste gas incinerator, if you don't know it, then come and have a look. Waste gas incinerator manufacturers have said so much about this knowledge point. I hope I can help you.


Key words: