How to choose the steam heat exchanger? Why is the effect not good?


Release time:

2022-10-25

How to choose the steam heat exchanger? The steam heat exchanger is mainly composed of many fins, and the steam inlet and outlet pipes are directly arranged on the fins.

蒸汽换热器要如何进行选择?为什么会出现效果不好的情况?

If you want to choose a suitable steam heat exchanger, you must first consider the power of the radiator. The heat generated by the radiator is sufficient to maintain the temperature of the medium to ensure that the steam heat exchanger can heat the medium from the initial state to the set temperature within the specified time.

During the operation of the steam heat exchanger, attention should be paid to maintenance. The surface of the equipment shall be kept clean at all times. When scrubbing the equipment, do not use its organic solvent, but use its mild detergent for cleaning.

In order to prevent collision with other objects or scratch the surface of the equipment, the steam heat exchanger adopts its closed heating system when in use, away from domestic water and pressure cooker. If the part is not hot, please open the air valve to release the blocked air, and close the air release valve when the water overflows. The heating system of this steam heat exchanger cannot be maintained with water. The water in the heat exchanger is drained to form a water-free maintenance. It is strictly forbidden that the water in the heat exchanger is not satisfied or part of the water stays in the heat exchanger for a long time.

During use, do not overtemperature or overpressure, so as not to affect its service life. Do not let one side of the steam heat exchanger be heated to avoid leakage. If leakage occurs, remove it in time. The heating and cooling speed of the steam heat exchanger cannot be too fast.

The possible reasons for the poor effect of steam heat exchanger are mainly as follows:

It is generally caused by the following factors: specification selection error, insufficient gas volume, poor condensate discharge, waterway blockage, serious fouling of the internal pipeline of the steam heat exchanger, etc.

1 Selection is not appropriate

In the case of circulating water flow and heating steam flow without fault, should ensure that the inlet pressure above a certain level, condensate discharge temperature to be high; air pressure drops, the heat will be reduced. The choice is too small, the condensate discharge temperature is high, and the heat is wasted. When the steam pressure is low, the heating capacity cannot be guaranteed, so the steam heat exchanger should be replaced or increased in time.

2 Condensate water discharge is not smooth

If the trap is blocked, as long as the trap is cleaned up, it can be solved in time. In addition, the design of the condensed water pipe is too small, which will also lead to poor discharge of condensed water, and the heat exchange capacity is difficult to adjust. In this case, it is necessary to enlarge the size of the condensate pipe.

3 Insufficient gas volume

This shows that when the inlet pressure of the steam heat exchanger is low, the heat exchange cannot be guaranteed. Check that the pressure reducing valve is in the correct position. If the pressure in front of the pressure reducing valve is low and the pressure reducing valve cannot be started, the bypass valve of the pressure reducing valve should be opened. If the pressure before the main steam valve is too low, check the steam source. Only if the pressure is sufficient, the steam heat exchanger can supply enough gas.

4 Blocked waterway

The blockage of the waterway leads to a decrease in the water flow of the steam heat exchanger and a decrease in the heat transfer coefficient. Treatment method: one is backwashing, and the other is to disassemble the steam heat exchanger for cleaning. One of the reasons for the blockage of the water path of the steam heat exchanger is that the impurities in the newly built pipe network before installation are mostly caused by unfiltered water before entering the water.

Therefore, the steam heat exchanger should be well maintained, and the dirt in the decontamination device should be discharged regularly. At the same time, pay attention to the external environment to reduce the damage of water quality to the pipeline.


Key words: