How is the steam heat exchanger operated? How can damage be reduced?
Release time:
2022-10-17
Steam heat exchangerHow do I do it? How do I reduce damage?

1. Some preparations before use
(1) Check whether the static grounding of the steam heat exchanger is good.
(2) Check whether the anchor bolts and connecting flange bolts are loose.
(3) Check whether the import and export valves are in good condition and whether the handwheel is complete and easy to use.
(4) InspectionSteam heat exchangerWhether the shell surface is free of deformation, bruise, crack, rust spot and other defects.
(5) Check whether the temperature, pressure gauge and other instruments work normally.
(6) It can be used only after passing the pressure test.
2. Precautions when using
(1) It is strictly prohibited to overtemperature and overpressure, so as not to affect the service life and damage the equipment.
(2) It is forbidden to heat one side of the heat exchanger to avoid leakage. Once leakage occurs, it should be removed in time.
(3) It is strictly forbidden to heat up or cool down too fast.
(4) It is strictly forbidden to close the vent valve half to avoid oil leakage or fire.
(5) When the steam heat exchanger leaks, the steam heat exchanger should be removed.
(6) Check the pressure and temperature changes and whether the steam heat exchanger leaks.
(7) often check the big head cover, pipe box, exhaust valve and other flange connections for leakage.
3. When put into use
(1) Discharge the water in the steam heat exchanger, and perform steam infiltration and preheating. when the steam permeates,Steam heat exchangerExposure to steam.
(2) Empty and purge the body, and pay attention to the shell side and tube side at the same time. When the temperature stabilizes, the cold fluid valve and the hot fluid valve are fully opened.
(3) Before putting into use, check whether the vent valve is closed tightly to avoid oil leakage or fire.
(4) When starting the heat exchanger, cold oil should be introduced first, and then hot oil should be introduced to avoid leakage caused by rapid deformation of the equipment.
(5) Start to drain the oil slowly, slightly open the vent valve of the oil cooler, fully open the outlet valve of the oil cooler, and then slowly open the inlet of the oil cooler. When the exhaust valve sees oil, close the exhaust valve immediately until the steam heat exchanger is full of oil.
(6) The pumping speed of hot oil should be slower to prevent a small amount of stored water from being suddenly heated and vaporized, causing the pressure to rise sharply and damage the equipment. Slowly open the hot oil vent valve, fully open the hot oil outlet valve, and then slowly open the hot oil inlet. When the exhaust valve sees oil, close the exhaust valve immediately until the steam heat exchanger is full of oil.
Key words:
Recommend News