Finned tube heat exchanger using skills


Release time:

2022-09-09

finned tube heat exchangerCan also use steel belt; stainless steel belt, copper belt, aluminum belt and so on. Airfoil heat exchangers are mainly used for air heating in drying systems. It is the key machine and device in the wind turbine equipment. The heat medium selected for the radiator can be steam or hot water. Generally speaking, it does not exceed 0.8MPa, the hot air temperature is below 150, and the wings are too high and too dense, which will enhance the difficulty coefficient of the processing technology and increase the production cost.

翅片管换热器使用技巧

Iffinned tube heat exchangerToo dense, it is very easy to cause ash, it is difficult to remove ash. Therefore, how many wing tubes are selected to calculate the wing ratio, that is, the total heat transfer area after wing enhancement is the ratio of the total area of unrelated wings. According to normal regulations, it is generally determined that the wing is better at about 5 to 10, so when choosing the wing tube, you must choose the correct selection. The principle of things is reversed.

Finned tube heat exchanger is a commonly used form of heat exchanger in refrigeration, air conditioning, chemical and other industries. The heat transfer resistance of finned tube heat exchanger is mainly concentrated on the fin side. Therefore, optimizing the fin side structure of heat exchanger is the key point to improve the performance of finned tube heat exchanger. The fin side of the finned tube evaporative heat exchanger used in room air conditioning basically operates under wet conditions.

When the finned tube heat exchanger is in a wet state and the surface temperature of the fin is lower than the dew point temperature of the wet air, the water vapor in the wet air begins to condense and precipitate on the surface of the fin. At this time, condensation droplets appear on the fin surface. With the continuous precipitation process, the droplets will gradually grow under the combined action of gravity and airflow traction and flow out of the fin surface.

When purchasing finned tube heat exchangers, the cost and heat exchange effect are also considered. Willfinned tube heat exchangerThe reduction of the main diameter to the appropriate range can significantly reduce material costs, significantly reduce the amount of thermal energy filled, and save resources and costs in many ways. Although the diameter of the main pipe of the finned tube heat exchanger you buy is reduced, its heat transfer coefficient increases. The compact structure can strengthen the temperature transfer between the pipes and reduce heat loss. The finned tube can also increase the heat dissipation surface area, but we also need to understand that at the same time, the heat exchange speed of the small diameter finned tube radiator is better than that without finned tubes. Heat exchange equipment is fast.


Key words: