How to install the finned tube heat exchanger assembly?
Release time:
2022-08-25
How to installfinned tube heat exchangerComponents?
Finned tube radiators are widely used in gas and liquid heat exchangers. The fins are added to the ordinary base tube to enhance heat transfer. Can use steel pipe; stainless steel pipe; copper pipe, etc. Wings can also use steel strips; stainless steel strips, copper strips, aluminum strips, etc., so how to install finned tube heat exchanger components?

How to install the finned tube heat exchanger assembly?
1. Before installation, it is necessary to measure on-the-spot measurement to determine the model, quantity and specific installation position of the wing tube radiator.
2. Various accessories for radiator installation, such as plates, pliers and cones.
3. Installation includes positioning, trench, pipe routing, pipe connection, water supply installation and pressure test.
4. Installation, later installation of wing tube radiator (including connection of fixed suspension of wing tube radiator, connection of valve with wing tube radiator and heating pipe), pressure test of the whole system and debugging of wing tube radiator.
5. Before or after construction of other decoration processes, pay attention to the construction before construction.
6. If the heating is installed before the decoration, the pipe connected to the wing tube radiator is buried under the floor and under the wall. Do not leak the pipe to the outside to avoid damage.
7. When selecting, the number of pieces, single pieces, spacing, water inlet mode and interface spacing should be accurately retained to avoid later installation of wing tube radiators.
8. The finned tube radiator is a heat exchange device. Plumbing uses wall-mounted boilers or boilers to heat circulating water, and then connects to the wing tube radiator through a pipe, and then outputs a suitable temperature through the wing tube radiator to form an indoor temperature difference. Then the thermal cycle is carried out to make the indoor temperature rise evenly.
finned tube heat exchangerWhat is the role in?
1. The basic function of the finned tube heat exchanger is to transfer heat, and the heat of the hot fluid is transferred to the cold fluid. The heat switch transfers more heat. Under the premise of considering fluid resistance and non-fluid induced vibration, high flow rate is selected as far as possible. For the constant fluid, try to use the heat transfer method close to the countercurrent. The purpose of this is to increase the average temperature difference and reduce the temperature stress in the structure. In addition, when conditions permit, the inlet temperature of the hot fluid of the finned tube can be increased to reduce the inlet temperature of the cold fluid.
2. Proper tube spacing or arrangement can not only increase the heat transfer area of fin tubes per unit time, but also improve the flow characteristics, especially the heat transfer effect of rough tube bundles is better than that of tubes. If one side of the heat exchange device changes with each other and the other side of the fluid is a gas phase, the heat transfer surface on the heat transfer area of the gas phase side can be increased, and the heat transfer area can be increased, which is beneficial to the heat transfer.
3.finned tube heat exchangerIt is mainly composed of three rows of airflow to the room. Using it not only saves the use area, but also has better heat dissipation effect and saves energy. Good-looking appearance, since the listing, favored by customers. It is a good heating product. The choice of finned tube and finned tube heat exchanger mainly affect the fin ratio. The boiling ratio is closely related to the film heat transfer coefficient of the inner and outer media.
Key words:
Recommend News